RossGear - Distribution and Monitoring

CMA-8011A-7 - Leitch Compatible
SDI Component Monitoring and Reclocking Amplifier
A convenient and cost effective solution to signal distribution and picture monitoring requirements in serial component systems.

• 6 or 7 Reclocked SDI and 1 or 2 monitoring outputs jumper selectable
• Input equalization for up to 1,000 ft. (305 m) of cable
• Excellent chroma modulation accuracy
• Cable equalization for monitor outputs
• 5 year transferable warranty
• Fits Ross 8000 Series and Leitch 6800 Series frames
• Total Watts 3.3

Serial Video Input
Signal Standards Accomodated:		SMPTE 259M (conversion at 270Mb/s only)
Input Impedence:		75 Ohm terminating
Return Loss:		>19dB to 270MHz
Common Mode Rejection:		>20V pp @ 50/60Hz
Equalization:		Automatic, up to 32dB (300m of Belden 8281 cable @270Mb/s)

Serial Video Output
Signal Standards Accomodated:		SMPTE 259M
Number of Outputs:		6 or 7
Output Impedence:		75 Ohm
Output Return Loss:		>18dB to 270MHz
Signal Level:		800mV +/- 10%
DC Offset:		<+/- 50mV
Rise & Fall Time:		>850pS typical (20-80%)
Overshoot		<8% typical

Analog Monitoring Outputs
Video:		NTSC or PAL composite video, 1 V pp
Number of Outputs:		1 or 2
Output Impedence:		75 Ohm
Output Return Loss:		>35dB to 6MHz
Output Isolation:		>34dB to 6MHz
Signal Level:		1V pp +/- 5%
DC Offset:		<+/- 50mV
Frequency Response:		+/- 0.25dB to 5MHz typically -1.75dB @ 5.75MHz
Differential Phase:		<1.2%
Differential Gain:		<1.5%
Group Delay:		+/- 10ns to 5.5MHz
RMS Noise 0-5MHz (unweighted):		-52dB 0 - 5.0MHz

Power Consumption
Positive Rail:		475mA
Negative Rail:		10mA
Total:		3.3W

Specifications and design are subject to change without notice.