Digital Production Switchers - Synergy 4 SD

Width:

56.25" (143.9 cm)

Height:

12.5" (31.8 cm)

Depth:

29.0" (73.7 cm)

Height above desktop:

10.0" (25.4 cm)

Primary pushbuttons:

35

Width:

54.75" (146.7 cm)

Depth:

28.0" (70.5 cm)

Width:

19" (48.3 cm)

Height (11RUs):

19.5" (49.5 cm)

Depth:

19.25" (48.9 cm)

Video:

BNC Type

Editor:

D Type, 9 pin

Peripheral 1 & 2:

D Type, 9 pin

DVE 1 & 2:

D Type, 9 pin

GPI I/O:

D Type, 25 pin

To control panel:

8 pin shielded Telco

AC Power (primary and redundant):

3 pin IEC

Remote 1 through 8:

D type, 9 pin

Tally out 1 through 4:

D Type, 25 pin

To rack frame:

8 pin shielded Telco

AC power 1 & 2:

3 pin IEC

Input voltage:

90V~250V AC, 47~63Hz

Control panel:

350 VA

Frame (with no options):

175 VA

Frame (with all options):

600 VA

Panel and rack frame separation:

1000 ft (305 m) max

Ambient temperature range:

0 - 40 degrees C

The video processing circuitry is cooled by three fans using side-to-side airflow. The power supplies have independent fan cooling using bottom to top airflow with intakes and vents at the side.

10 bit 4:2:2 component digital video and key processing

256 levels of key transparency

4:3 and anmorphic 16:9 switchable aspect ratio

Number of inputs:

32, 40, 48, 56, or 64

Equalization:

> 150 m

Impedance:

75 ohm, terminating

Return loss:

> 20 dB

All inputs are SMPTE-259M-C serial digital non-looping.

The Synergy 4 comes standard with 32 inputs and additional inputs are purchased in sets of 8.

Inputs can be used for either key or video.

The reference input is SMPTE-259M-C and is chosen as one of the standard inputs. External A-D conversion is required for analog references.

MLE 1, 2 & 3 PGM:

1 each

MLE 1, 2 & 3 PV:

1 each

MLE 4 PGM (main PGM):

2

MLE 4 PV:

1

Main PV without overlay:

1

Main PV with overlay (option):

1

Clean feed:

1

Expansion (future use):

4

Aux Bus (1 to 12):

1 per bus

Return loss:

> 18 db @ 270 MHz

Rise time:

800 ps +/- 10%

Signal level:

800 mV +/- 10%

DC offset:

0 volts

Rise and fall time:

1 ns (20 - 80%)

Overshoot:

< 8%

All video outputs are 10-bit SMTPE-259M-C serial digital.

EDH is inserted into all video outputs except untimed Aux Buses and can be disabled.

All video inputs zero time relative to reference input, auto timing will correct for inputs out of time by up to +/- 0.25 line (16us).

The delay through the switcher is less than one one-quarter line (approx. 12us). This delay can be manually increased in 37ns steps to a maximum of 32us in order to accomodate late video signals.